Dayton Audio AMT3-4
tweeter · nominal (partial) — Dayton Audio datasheet (https://www.daytonaudio.com/images/resources/275-093--dayton-audio-amt3-4-spec-sheet.pdf)
Thiele/Small parameters
| Fs (resonance) | 875 Hz |
| Qts | — |
| Qes / Qms | — / — |
| Vas | — |
| Re / nominal Z | 3.7 Ω / 4 Ω |
| Xmax | — |
| Sensitivity | 93 dB (2.83 V/1 m, mfr) |
| Power handling | 25 W |
Published (nominal) values, params partial — verify by measurement (DATS/REW) before building.
Datasheet (PDF) ↗ — manufacturer-hosted
Recommended enclosures
This is a tweeter; Thiele/Small box parameters are not used for enclosure design.
Affiliate disclosure: some links are affiliate links and we may earn a commission on qualifying purchases at no extra cost to you. Prices are estimates at the time of writing; verify on the retailer's site.
About this driver
The Dayton Audio AMT3-4 is a 3″ tweeter with a free-air resonance of 875 Hz. See the sealed vs ported guide for how to choose.
Recommended partners
modeled estimateThe woofers and midranges below pair well with the Dayton Audio AMT3-4 in a two-way design — each grade is a modeled estimate of the crossover match, with a suggested crossover point. Open any pair in the guided builder to design the crossover and total the parts.
- Peerless by Tymphany TC9FD18-08Good match· 96/100
Suggested crossover 2.42 kHz (4th-order, Linkwitz-Riley)
Build this pair → - Dayton Audio CE65W-8Good match· 92/100
Suggested crossover 3.26 kHz (4th-order, Linkwitz-Riley)
Build this pair → - Dayton Audio DS90-8Good match· 92/100
Suggested crossover 2.61 kHz (4th-order, Linkwitz-Riley)
Build this pair → - Dayton Audio ND65-4Good match· 92/100
Suggested crossover 3.70 kHz (4th-order, Linkwitz-Riley)
Build this pair → - Dayton Audio ND65-8Good match· 92/100
Suggested crossover 3.59 kHz (4th-order, Linkwitz-Riley)
Build this pair → - Dayton Audio ND90-4Good match· 92/100
Suggested crossover 2.61 kHz (4th-order, Linkwitz-Riley)
Build this pair →
Modeled estimate from T/S + geometry — no measurements. The verdict is robust; it improves with measured FRD/ZMA data.